Click To Call(689) 329-1673Click To Get A Free Estimate
Herringbone paver driveway half washed with new sand being swept across it

Clean pavers and full joints, free of green

Paver Cleaning and Joint Sand in St. Cloud, FL

Call (689) 329-1673 for a free estimate to clean and re-sand the pavers at your home.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.50 to $3.00 a sq ft to clean, sand and seal
Call Now(689) 329-1673

Can I get my pavers cleaned in St. Cloud without a long wait?

A local contractor cleans pavers across St. Cloud, FL, and you will hear back within 1 business day, usually much sooner. Fresh joint sand is part of the job, and the free estimate carries no pressure to book. To start, call (689) 329-1673.

Cleaning lifts the algae, stains and ground-in dirt that dull pavers, so the surface looks brighter and grips better underfoot. New sand then fills the joints, which ties the pavers together and leaves weeds little room. The side walk that went green in the shade can match the rest of the yard again. Point out the worst spots when you send the free estimate form.

Call (689) 329-1673

Brick paver walkway with one grimy section next to a freshly cleaned section

What is part of a paver cleaning job in St. Cloud?

Expect a treatment for what is growing on the pavers, a controlled wash and new joint sand once the surface dries. Choose it by itself, or use it as the opening stage of a sealing job. Shaded edges and the spots next to sprinkler heads usually take the longest. To line up a cleaning, call (689) 329-1673.

Treatment first

An algaecide goes on before the wash to kill algae, mold and weeds at the root, and any stain cleaner is tested on a small spot.

Controlled wash

A high-volume, low-pressure wash covers the area evenly, and the spray stays at a shallow angle so sand stays in the joints.

Fresh joint sand

Sand is swept into every gap once the pavers dry and then wet down to settle it.

Sealer if you want it

A coat of sealer can go on afterward, once everything has dried. The sealing guide explains what that adds.

What are the signs my pavers need cleaning?

Look for a green or black film on shady edges, orange streaks near the sprinkler heads, weeds in the joints and sand piled on the driveway after a downpour. Leaves left sitting break down into tannins, A Cleaner Touch says, and fertilizer granules can etch the surface. Algae is the urgent one on a walk or pool deck. To have yours looked at, call (689) 329-1673.

Should I clean my pavers only, or seal them too?

Cleaning fixes how the pavers look today, and sealer influences how long that look lasts. Cleaning alone costs less today, but algae and fading return on their own schedule. A coat makes the next wash easier, and it becomes a repeat job every few years. Share your preference with the contractor when you send the free estimate form.

How often should St. Cloud pavers be cleaned?

Once a year suits most homes, and Kennelly Paver and Restoration suggests a maintenance wash every 12 to 15 months. A shaded walk or a patio under the roofline may need it sooner than a sunny drive. To set a schedule, call (689) 329-1673.

Does more pressure clean pavers better?

No. Unilock says to keep the spray at an angle no greater than 30 degrees so the joint material stays put, and it warns that the wrong pressure or nozzle can crack pavers or erode the surface. A stronger blast empties the joints and can scar a softer face. Find out the pressure and nozzle size when you send the free estimate form.

Unilock also says to inspect the joints once the pavers are rinsed and to sweep in new joint material where it is needed. The sand locks the pavers together, so losing it costs as much as leaving the dirt. If you want to hear how a contractor deals with it, call (689) 329-1673.

Rust marks

What causes orange sprinkler marks at my St. Cloud home?

Iron in the water is the usual culprit. According to UF/IFAS, iron is common in Florida well water, and rust deposits form on anything the spray reaches. Toho Water Authority also sets watering days by house number, so the same spot can get sprayed twice a week. A rust treatment made for pavers lifts the marks, and A Cleaner Touch advises angling sprinkler heads away from the pavers. Point out the marks when you call (689) 329-1673.

What is the white film on my pavers?

On newer pavers the cause is usually efflorescence, which is natural salt moving up to the surface. Unilock says it often fades on its own in two to three months and sometimes takes up to a year, and sealing should wait until it is gone. A sealer that has turned cloudy can look much the same. Show the contractor the spot when you send the free estimate form.

Surfaces

Which paved areas can be cleaned at a St. Cloud home?

Any paved area at the house can be cleaned, whether it is the driveway, the pool deck, the patio or the front walk. Different grime lands on each, so the treatment shifts. To start with yours, send the free estimate form.

Driveways

A Central Florida company that seals pavers says the tire paths fade first on a driveway, and oil lands where the car sits. Cleaning here pays off most along those tire lanes.

Pool decks and lanais

Castle Clean and Seal notes that pool decks face chlorinated water and constant moisture. Cleaning around a pool should leave a surface that still grips and still drains.

Patios

Covered or partly shaded patios tend to grow more algae and mold than sunny driveways, Castle Clean and Seal says. Cleaning on a patio goes after the green film along the shaded edge.

Walkways and entries

A Cleaner Touch says leaves break down into tannins and fertilizer granules can etch the surface, and both end up along a front walk. Cleaning at the entry is a small job, and guests step on it first.

Common problems

What leaves St. Cloud pavers dirty?

Dulled tire lanes, sprinkler spray, sand lost at downspouts, damp shade and old sealer lead the list. A cleaning takes care of several of these, while sealing or repairs deal with the others. To find out which apply at your home, call (689) 329-1673.

1. Tire lanes that dull first

A Central Florida company that seals pavers says Orlando sits in a high-UV zone with long, hot summers, and that on a wet look driveway the tire paths fade first. A wash shows how much color is left, and sealer afterward slows the fading.

2. Sprinklers on a fixed schedule

Toho Water Authority sets watering days by house number, so the same spray can hit the same wall twice a week. UF/IFAS says most Florida well water is high in iron, and homes on a private well can end up with orange streaks.

3. Sand washing out at downspouts

A Central Florida company that seals pavers lists joints that loosen or wash out near downspouts and slope breaks as a sign of wear. Once the sand goes, weeds and shifting pavers follow.

4. Green film in damp shade

Orlando gets over 50 inches of rain a year, an Orlando paver company says, and humid air grows algae and mold on unsealed surfaces. Castle Clean and Seal adds that covered or partly shaded patios tend to grow more algae and mold than sunny driveways.

5. Old sealer that turned cloudy

A sealer that has gone white, cloudy or started to peel has to be chemically stripped before a new coat can bond, according to an Orlando paver company. Stripping is the step that changes a quote the most.

Pricing

What does paver cleaning cost in St. Cloud?

A plain pressure wash runs $0.15 to $0.75 per square foot, according to Kennelly Paver and Restoration. That puts a 900 square foot driveway between $135 and $675 and a 500 square foot patio between $75 and $375. Joint sand is a separate line, and an algae or rust treatment can add to the price. For a number on your property, send the free estimate form.

Thinking about sealing too? Ask for a combined price, since the whole job runs $1.50 to $3.00 per square foot across Central Florida. To weigh the two options, call (689) 329-1673.

Want the pavers protected too? See the sealing guide, or browse the towns served around St. Cloud.

Paved areaPressure wash onlyClean, sand and seal
500 sq ft$75 to $375$750 to $1,500
900 sq ft$135 to $675$1,350 to $2,700
1,500 sq ft$225 to $1,125$2,250 to $4,500

For the wash column, the rate is the $0.15 to $0.75 per square foot Kennelly Paver and Restoration lists for a standard pressure wash. For the sealing column, the rate is the $1.50 to $3.00 per square foot Central Florida companies published as of November 2026. A quote for joint sand is separate from a wash, and your own quote may differ.

Get a Free Estimate

Pool deck pavers and a screened lanai at a lakeside home, ready for a wash
Why choose us

Why use a local contractor for paver cleaning in St. Cloud?

A contractor who works around St. Cloud knows what humid air, shade and a fixed watering schedule leave on pavers. Compare any quote with the published rates on this page, and take as long as you like to decide. To begin, send the free estimate form.

Contractors who work in Osceola County

A company that covers St. Cloud already plans around the afternoon storms, the summer sun and the watering schedule. That makes the first visit more useful.

Free to ask

There is no charge for the look or the quote. Turn the price down and nothing more happens.

A range you can check

Central Florida paver companies publish $1.50 to $3.00 per square foot to clean, sand and seal, and this site shows the same range. A quote far outside that range is worth asking about.

You decide when

Ask for the price in writing and decide when you are ready. Read the contractor standards page for the points worth confirming first.

Want a free estimate to clean your St. Cloud pavers?

Fill in the short form or call, and an answer comes back within 1 business day, often much sooner.

Call (689) 329-1673

Free, no obligation

Contractor going over a cleaning plan with a homeowner couple beside their paver drive
Photos

How do cleaned pavers look around St. Cloud?

Wide sealed gray and tan paver driveway with homeowners beside a lakeside street on a St. Cloud property
Family on lounge chairs by a sealed paver pool deck inside a screened lanai on a St. Cloud property
Sealed herringbone paver walkway leading to an arched front door on a St. Cloud property
Sealed paver patio with a dining table at golden hour beside a cypress-lined lake on a St. Cloud property
Close view of sealed travertine pavers with clean joints on a St. Cloud property
Shaded paver patio with one cleaned half beside a mossy half on a St. Cloud property
Contractor running a surface cleaner over a brick paver driveway on a St. Cloud property
Two contractors spraying and rolling sealer on a paver driveway on a St. Cloud property
How it works

How does the paver cleaning process go, step by step?

Choosing no sealer ends the visit after the third step, with the joints full. To set a date, call (689) 329-1673.

1. Measure and ask

The contractor measures the area for the cleaning quote, marks sunken pavers and old sealer, and asks which days the sprinklers run.

2. Treat and wash

An algaecide goes on first to kill algae, mold and weeds at the root. A high-volume, low-pressure wash then lifts the growth without blasting the joints.

3. Refill the joints

Joint sand is swept in once the surface dries. It is then wet down so it compacts, a step Kennelly Paver and Restoration calls hydro-compacting.

4. Test for moisture, then coat

Western Interlock describes taping plastic sheeting over the pavers to see if condensation forms. If the plastic stays clear, a sprayer lays the sealer down and a dry roller takes up the puddles.

5. Walk the job with you

The contractor goes over the finished area and gives the stay-off times for the product used. Castle Clean and Seal lists 4 to 6 hours for feet, about a day for furniture and 48 hours for cars.

Questions

Frequently Asked Questions

How much to clean and seal pavers?

Published Central Florida pricing for a clean, sand and seal is $1.50 to $3.00 per square foot, which puts an 800 square foot St. Cloud driveway at about $1,200 to $2,400. A plain pressure wash costs far less, since Kennelly Paver and Restoration lists $0.15 to $0.75 per square foot for one.

Is it necessary to seal pavers in Florida?

No, pavers work without it. Unilock says its pavers do not require a sealer and calls sealing optional. In Central Florida's humid air, though, bare pavers grow algae and fade sooner, so many homeowners add a coat after a cleaning to keep the surface easier to wash.

Is it a good idea to pressure wash pavers?

It is when a contractor keeps the pressure low and refills the joints afterward. Unilock names pressure washing as quick for big areas and says the wrong pressure or nozzle can crack pavers or blow sand out of the joints. Ask what pressure and nozzle the contractor will use.

How often do you need to reseal pavers in Florida?

Every two to five years, depending on the finish and the surface. Cleaning between coats helps, and Kennelly Paver and Restoration suggests a maintenance wash every 12 to 15 months. A cleaning is also the right first step when the time for a new coat arrives.

What should a contractor never use on my pavers?

A wire brush and a harsh acid wash top the list. Unilock says wire bristles leave metal particles that rust and stain, and A Cleaner Touch says harsh acids and solvent cleaners can strip protection quickly. Ask which cleaner the contractor uses and where it gets tested first.

Does paver cleaning in St. Cloud include new joint sand?

It should, so ask for it in the quote. Unilock says to inspect the joints after the rinse and sweep in new joint material where it is low. Pressure lifts sand out, so a cleaning that skips this leaves the joints thin.

Why do shaded pavers in St. Cloud turn green so fast?

Humid air and shade keep the surface damp, and algae needs only that. Kennelly Paver and Restoration says humidity promotes algae and mold on unsealed surfaces, and Orlando gets over 50 inches of rain a year. A sealed surface rinses clean more easily.

Can a contractor clean the pavers around my St. Cloud pool?

Yes. A pool deck with algae on it can be slick, which is a good reason to put it on the list. Castle Clean and Seal notes that pool decks face chlorinated water and constant moisture. Ask the contractor how the cleaner is kept out of the pool and away from nearby plants.

Pick a day to freshen your St. Cloud pavers

Fill out the short form or call, and a local company answers within 1 business day, usually much sooner.

Call (689) 329-1673

Free, no obligation